User manual

Advanced network
Cobalt Qube 3 User Manual 197
Advanced network
There are six further options under the Advanced Network option:
• review settings
• set up primary
• DHCP primary
• set up secondary
• DHCP secondary
• Exit
Review settings
To review the network settings on the Qube 3:
1. On the LCD console, hold down the button for approximately two
seconds. The LCD screen displays:
SELECT:
SETUP NETWORK
2. Press the button until ADVANCED NETWORK appears in the LCD
screen:
SELECT:
ADVANCED NETWORK
3. Press the button. The LCD screen displays:
SELECT:
REVIEW SETTINGS
4. Press the button. The LCD scrolls through the settings for the default
gateway, the primary IP address, the primary subnet mask, the secondary
IP address and the secondary subnet mask; each setting is displayed for
about five seconds. If an interface is disabled, the bottom line of the
LCD screen displays
Not Configured
.
5. The LCD screen then returns to the normal display with the fully qualified
domain name on the top line and the IP address on the bottom line.