User manual

Appendix A: Using the LCD Console
204 Cobalt Qube 3 User Manual
Reset network
This function is useful if you are moving the Qube 3 to a new network.
The Reset Network function resets the IP address and netmask for the primary
and secondary network interfaces to that of a new, unconfigured Qube 3. It also
resets the gateway, host name, domain name and DNS information to that of a
new, unconfigured Qube 3.
Resetting the network also disables the IP firewall filtering rules, if you had
enabled that option.
To reset the network state of the Qube 3:
1. On the LCD console, hold down the button for approximately two
seconds. The LCD screen displays:
SELECT:
SETUP NETWORK
2. Press the button until RESET NETWORK appears in the LCD
screen:
SELECT:
RESET NETWORK
3. Press the button.
4. Use the arrow buttons to toggle the cursor between [Y] and [N]. Select [Y] to
reset the network configuration.
5. Press the button.
6. After resetting, the Qube 3 powers down and the LCD screen displays:
PLEASE SWITCH
POWER OFF NOW
7. Press the On/Off button the back panel to turn off the Qube 3.
✍
Note: If you have the Qube 3 Professional Edition (with RAID),
wait a few seconds before pressing the On/Off button.