User manual

Chapter 2: Setting up the Qube 3
18 Cobalt Qube 3 User Manual
An IP address consists of four numbers, ranging from 0 to 255, separated by
periods (for example, 192.168.25.77); this is often referred to as “dot-quad
notation”.
To enter the IP address for the Qube 3:
1. Use the arrow buttons on the LCD console to enter the IP address assigned to
the Qube 3.
2. Press the button to accept the IP address.
If the IP address is valid, the following prompt appears:
PRIMARY NETMASK:
0
00.000.000.000
3. Enter the netmask of your network.
4. Press the button to accept the entry.
If the netmask is valid, the following prompt appears:
ENTER GATEWAY:
0
00.000.000.000
5. Enter the IP address of the gateway for your network. If your network does
not have a gateway, do not enter a number. Press the button to accept
the default value of “000.000.000.000”.
✍
Note: A gateway or router address is not required for a Qube 3 that
is only connected to a local area network (LAN). If you connect to
another network through the Qube 3, you may require a gateway
address. If you connect to the Internet with a modem, you do not
require a gateway.