User manual

Setting up the RaQ 3
25
For informational purposes, this table also displays the IP address of the
RaQ 3, the subnet mask of your network, your configured gateway and
the Media Access Control (MAC) address that uniquely identifies this
RaQ 3. These settings, with the exception of the MAC address, can be
changed later (through the browser) from the Control Panel section of
the Server Management screen.
Entering the administrator settings
In the Administrator Settings table, enter the information about the
RaQ 3 Administrator. The RaQ 3 Administrator has several
responsibilities:
1. Setting up and maintaining the RaQ 3, virtual sites, virtual Site
Administrators, site users and services
2. Responding to RaQ 3 email alerts to prevent potential problems
To set up the RaQ 3 Administrator, you must enter a password in the
Administrator Password field and then enter the same value again in the
second Administrator Password field. Use the following guidelines
when choosing a password:
1. Use between five and ten alphanumeric characters; ten is the
maximum number of characters allowed. The valid characters
include: a-z A-Z 0-9 % ! @ $ ^ & * - _ = + \ | . , / ? ; :
2. Use both upper- and lower-case letters.
Note: A password is case-sensitive.
3. Do not use a proper name.
4. Do not use a word found in a dictionary.
5. Do not use a date.
6. Do not use a command word.
7. Do not use a string of consecutive keys on a keyboard (for example,
“qwerty”).
Be sure to remember this password to access the RaQ 3’s management
administration features in the future. If you forget or want to reset the
password, see “Resetting the RaQ 3 Administrator password” on
page 46.