User's Manual

NETNode
Phase 1 and 2 Units
NETNode
User Manual
NETNode-V2.3
2-12
DS000034 Unclassified
A domo MESH Phase 2 Weatherproof NETNode is supplied with the following cables:
 IP via Ethernet x 1 and DC Power is combined Part Number CA0403
 Control 2m x1 Part Number CA0406
 AV 2m x1 (if the NET-AVI-UP2R option is ordered) Part Number CA0477
A domo MESH Phase 2 Plain NETNode is supplied with the following cables:
 Standard 12V Power Block Part Number CA0023
 Control cable 2m x1 Part Number CA0001
 Special Control / Data Cable Part number CA0474
 AV 2m x1 (if the NET-AVI-UP2P option is ordered) Part Number CA0122
Before deploying domo MESH NETNode units in the field it is strongly advised to test the
products in a bench environment in order to gain familiarity with the product.
BEFORE SWITCHING ON THE UNIT PLEASE NOTE:
The DC power supply must be set to 12.5V and assume up to 2.5A of current draw.
2.6. Establishing Connection to a Node
Once a user has connected to a unit and established a NETNode on their network operating
the system is easy.
The procedure to establish communication with a node varies depending on whether the
User wishes to connect the MESH to a network running DHCP or whether the user wishes to
run with static IP addresses.
If your network has no DHCP server you will need to assign a fixed IP address for the
NETNode using a serial RS232 interface. If you have a DHCP server the NETNode will
automatically acquire an IP address and you can connect straight via IP. You may still wish
to change the DHCP IP address to a fixed IP address using the browser.
2.6.1. Connecting the NETNode to your Computer using Serial (RS232)
The first time you set up a NETNode with no DHCP you‟ll be connecting using a serial RS232
interface.
You‟ll only have to do this once – every other time you‟ll hook up to the NETNode using an
IP interface using a web browser.
On a Phase 1 Unit
1. Connect the Amphenol 19-way plug (m) from CA0288-5 cable to the Amphenol 19-way
jack (f) on the NETNode labelled CTRL/DATA.