User's Manual

NETNode
Phase 1 and 2 Units
NETNode
User Manual
NETNode-V2.3
2-15
DS000034 Unclassified
Once a valid IP address is set it may also be changed in the WEB browser.
Now that the IP address is established the web-server should be used to configure frequency
and output power. Once the node is on the User network any Web-browser can be used to
browse to the Mesh NETNode to configure and control the node or to browse network
status. The unit can be browsed by entering the relevant IP address in the web-browser.
2.6.3. Connecting the NETNode to your Computer using IP
For the rest of the set up of the NETNode you‟ll be connecting using an IP interface and a
web browser.
On a Phase 1 Unit
9. Connect the Amphenol 19-way plug (m) from CA0288-5 cable to the Amphenol 19-way
jack (f) on the NETNode labelled CTRL/DATA.
10. Now, connect the RJ45 8-way plug (m) to your computer‟s RJ45 8-way jack (f).
On a Phase 2 Robust unit
11. Connect the Amphenol plug (m) from CA0403cable to the Amphenol jack (f) on the
NETNode labelled Power/IP. (This cable also includes the DC power banana plugs.)
12. Now connect the RJ45 8-way plug (m) to your laptop‟s RJ45 8-way jack (f).
13. Ensure you know the IP address of the computer you have attached.
On a Phase 2 Plain box unit
On a Phase 2 Plain box unit simply connect to one of the RJ45 panel mount sockets labelled
1 or 2 on the NETNode unit. It does not matter which socket you use.