User's Manual

NETNode
Phase 1 and 2 Units
NETNode
User Manual
NETNode-V2.3
2-17
DS000034 Unclassified
Set Output level select to „Low‟ and set Enable „ON‟ by „ticking‟ the check box.
Note: Click „Apply‟ after changing any configuration setting
Check that the Frequency is valid for the operation of the unit – specific country regulations
will determine the frequencies available for operation. Note that 2400 to 2480MHz is licence
exempt in most of the world.
For the units to function in a single network the following must be set correctly:
1. All units must be set to the same frequency
2. All units must have the same channel bandwidth set
3. All units must have their Transmit enabled
4. All units must have the same mesh ID
5. Each unit should be assigned a different node ID (0-7).
6. If encryption is enabled then the encryption type and keys must match.
Mesh
ID