User's Manual

NETNode
Phase 1 and 2 Units
NETNode
User Manual
NETNode-V2.3
2-25
DS000034 Unclassified
3.2. Starting Up and Shutting Down the NETNodes
3.2.1. Powering up the NETNodes
You‟ll need at least two fully configured NETNodes. (If they are not, then see advanced
procedures).
1. Connect the live power cable to the NETNodes.
2. On the front panel, the Power LED will show solid green.
3. Do Nothing! - Leave the system to form a mesh automatically.
4. After about 5s on the front panel, the RF Connected LED will show solid green on each
NETNode. This indicates that the Mesh units are connected. If this does not happen
recheck the configuration of each unit individually.
5. The mesh system is now ready for operation.
3.2.2. Shutting Down the NETNodes
Disconnect the power cable from each of the NETNodes.