User's Manual

NETNode
Phase 1 and 2 Units
NETNode
User Manual
NETNode-V2.3
2-34
DS000034 Unclassified
4. Advanced Procedures
4.1. Status Tab – Overview Pane
Now you have got the NETNodes configured, let‟s take a look at the rest of the configuration
possibilities. We‟ll begin with the Status tab.
Here is the Status tab with the focus on the Overview pane.
4.1.1. Node ID
We are showing six NETNodes with Node IDs of 1, 2, 4, 5, 6 and 7. There could be up to
twelve NETNodes in a mesh with Node IDs numbered 0 to 11.
4.1.2. Unit Name
The unit name is a „friendly‟ name to make it easier for you to know which NETNode we are
talking about. This name is assigned in the Global Settings Tab.
4.1.3. IP Address
This shows the IP address of the unit that we set up in our initial configuration. Notice that it
is shown as a hyperlink. If you click on one of these hyperlinks the browser will switch to
that NETNode.
4.1.4. Battery Voltage
This returns the current battery voltage of the NETNode. Not so exciting when we are on
mains in the lab but vital when you are looking at a node located on a high building several
miles away which is running on batteries.