User's Manual

NETNode
Phase 1 and 2 Units
NETNode
User Manual
NETNode-V2.3
2-53
DS000034 Unclassified
Note: All configuration parameter changes need to be confirmed by clicking the „Apply‟
button before the changes are activated
4.5.2. Enable Transmitter Check Box
This simply turns on the transmitter when checked. All NETNodes in a mesh must have their
transmitters enabled.
4.5.3. Frequency
Input the frequency in MHz that you want to use for this NETNode.
4.5.4. Channel Bandwidth
You can configure the channel bandwidth with this combo box. There are three choices:
2.5 MHz
3.0 MHz
3.5 MHz
5.0 MHz (V2.1 software and unit types 68 upwards only)
See Section 4.12 Information Tab to discover the Board type and the Software version.
4.5.5. Output Level High and Output Level Low
These two text boxes allow you to set the level of attenuation in dB that will be applied to
the low and high output levels. This could be useful if your transmitter is swamping another
unit in close proximity. You can set anything between 0 to 30 dB.
4.5.6. Output Level Select
You can choose high or low output level to suit the RF environment you are working in.
When you select high or low here it applies any attenuation you have set in the output level
setting discussed above.