User's Manual

NETNode
Phase 1 and 2 Units
NETNode
User Manual
NETNode-V2.3
2-56
DS000034 Unclassified
4.7.2. Destination Mask
You can choose which NETNodes will receive the stream. Your NETNode could have up to
eight NETNodes attached to it via the mesh. Multicast streaming to all nodes is an inefficient
use of mesh capacity and so you need to be able to restrict the multicast to specific nodes.
1. Click the Destination Mask Set… button
2. The Streamer Destination Mask dialog will open
3. Check the node check boxes for the NETNodes that you want to receive the stream.
4. Click OK
When RTSP streaming is enabled this box will be greyed out and the destination mask
selected automatically as defined by the RTSP connection.
Note: The Eth0 and Eth1 are ticked by default. These ports will be used as the exit point
from the mesh at the node(s) you have specified.
4.7.3. Multicast Address
This text box enables you to change the multicast address used by the unit. The default
value is 239.16.33.254.