User's Manual

NETNode
Phase 1 and 2 Units
NETNode
User Manual
NETNode-V2.3
5-68
DS000034 Unclassified
1. Click the Destination Mask Set… button
2. The Streamer Destination Mask dialog will open
3. Check the node check boxes for the NETNodes that you want to receive the stream.
4. Click OK
Note: The Eth0 and Eth1 are ticked by default. These ports will be used as the exit point
from the mesh at the node(s) you have specified.
5.2.2.4. Multicast Address
This text box enables you to change the multicast address used by the unit. The default
value is 239.16.33.254.
5.2.2.5. SAP Address
This text box enables you to change the value of SAP/ SDP multicast address used by the
unit.
The default value is 224.2.127.254 and the port used is 9875.
These are standard multicast values for such parameters, and it is recommended they are
not changed unless specifically required due to routing restrictions.
5.2.2.6. Port
A good rule is to use numbers above 10,000 to avoid conflict with existing services.
When you set up a port number on several computers on a network they will all listen for
packets directed to that port.