User's Guide
Table Of Contents
- 0. Preface
- 1. Systems Description
- 2. Getting Started
- 2.1 Identifying your Device
- 2.2 Unpacking your Nano Transmitter
- 2.3 Unpacking your HD Nano Transmitter
- 2.4 About the Labels on your Nano Transmitter
- 2.5 Planning the Hardware Installation
- 2.6 Identifying the Variants of Nano Transmitter
- 2.7 Identifying the Options of Nano Transmitter
- 2.1 Identifying the Variants of HD Nano Transmitter
- 2.2 Identifying the Options of HD Nano Transmitter
- 2.3 About the Software with your Nano Transmitter
- 3. Controls, Connections and Indicators
- 3.1 About Controls, Connections and Indicators
- 3.2 Exploring the Top Panel – Nano Transmitter
- 3.3 Exploring the Bottom Panel – Nano Transmitter
- 3.4 Exploring the Side Panel – Nano Transmitter
- 3.5 Exploring the Top Panel – HD Nano Transmitter
- 3.6 Exploring the Bottom Panel – HD Nano Transmitter
- 3.7 Exploring the Side Panel – HD Nano Transmitter
- 4. Setting up your Nano Transmitter
- 5. Basic Operation
- 6. Advanced Operation
- 7. Advanced Setup
- 7.1 About Advanced Setup
- 7.2 Installing the Nano TX Controller on your PC
- 7.3 Connecting your PC to the Nano TX using Serial
- 7.4 Exploring the Nano TX Controller Main Window
- 7.5 Performing a Quick Setup
- 7.6 Working with the Unit Status Panel
- 7.7 Working with the Switch Panel
- 7.8 Working with the Unit Tab
- 7.9 Working with the Modulation Tab
- 7.10 Working with the Audio Tab
- 7.11 Working with the Video Tab
- 7.12 Working with the Misc Tab
- 8. Appendix A – Cautions and Warnings
- 9. Appendix B - Care and Maintenance
- 10. Appendix C-Glossary
- 11. Appendix D – Reference Material
Solo7 Nano Transmitter
Commercial in
Confidence
Video, Transmitters, Solo7 Nano
Transmitter
100145
Revision: 8.0
Commercial in
Confidence
Page 7-43
Screenshot: The Unit Status Panel
Figure 7-5 The Unit Status Panel
Step 1: Interpret the Toolbar
No
Name
Options
Notes
1
RF Button
Red=RF Off
Green=RF On
Click to toggle RF on or Off.
2
Video Lock
Red=Unlocked
Green=Locked
Tells you if the unit has successfully locked
to the video source.
Unlocked will also be shown if video is
disabled.
3
Audio Lock
Red=Unlocked
Green=Locked
Tells you if the unit has successfully locked
to the audio source.
Unlocked will also be shown if audio is
disabled.
4
Temperature
Green Symbol
Yellow Symbol
Red Symbol
An indication of the temperature of the
FPGA. Attempt to keep it green.
CAUTION: If it changes to red, switch the
unit off and allow it to cool.
0 to 59 degrees Celsius shown in green.
60 to 84 degrees Celsius shown in yellow.
85 degrees Celsius or above shown in red.
5
Logging
Dimmed-
Unavailable
White-Logging
running
Logging is normally off by default.
Logging is enabled by using a command
line switch which is fully described in
Appendix D,
Reference Material
.