User`s manual

100-M0056X2B 19 of 28
www.cobham.com/gms
(see figure 7a). To have the unit in the desired RF Power Mode on
Power up, it is necessary to store settings in the Others window. If the
settings are stored in the main page, the state of the RF Power Mode
will not be saved.
 Frequency switch – choices offered are enabled or disabled. These
are the four frequency select switches discussed under section 5.1.1.3.
If disabled the switches will not respond to changes (frequency changes
could still be accomplish by changing the “RF FREQ (MHz”) field in the
GMS MDLB control software. Enabling them allows the frequency to be
changed when the switches are changed. Factory default enables the
switches (keep in mind that you must click on the “Store All Setup
Pages) for the choice to take place.
 Video Filter Type-Pull down box offers various filter types for
optimizing picture. The choices include: LPF OFF, LPF C, LPF Y, LPF YC.
 Video Filter Frequency- Pull down box offers various filter
frequencies for optimizing picture. The choices include: AUTO,
12.15MHz, 10.6MHz, 9.45 MHz, 8.1 MHz and 6.75 MHz.
 Transport Stream (see figure 8) – The transport stream menu displays the
parameters of the current transport stream (of the transmitter). The fields are
read/write-able. Normally the fields require no manipulation and should work quite well
as defaulted from the factory. However, high end users may have a need to change the
transport stream parameters.
 Ctrl Port Baud Rate- The control port baud rate menu allows different baud rates to
be selected when attached to the PC RS232 port. Some computers may need the baud
rate adjusted for optimal communications
 Factory Setup – The menu is for factory use only.
Figure 6 - Select MPEG Encoder Profile