User`s manual
100-M0056X2B    5 of 28 
www.cobham.com/gms 
If any of the above variables change, such as a higher gain antenna, less or more power output from the 
transmitter, additional transmitters used, etc. then the safe distances would need to be recalculated. The 
user can either refer to the equations predicting RF Fields as noted in the above section or call contact 
GMS for advice at (760)-496-0055. 
Table 1 – Safe Distances 
Frequency = 1500 -
100,000 MHZ 
MDTB Transmitter Power = 
0.2W (+23 dBm) 
Antenna Gain = 
+2dbi 
 Occupational /controlled 
exposure (5mW/cm
2
) 
General population/uncontrolled 
exposure (1mW/cm
2
) 
Safe Distance  Average 
Time 
Safe Distance  Average Time 
2.2 cm  6 minutes  5 cm  30 minutes 
3.  The transmitter, which can be operated in fixed or mobile applications, is rated at 0.2W (+23dBm) RF 
power and is capable of harmful radiation if safe operating practices are not observed (see sections 1 
& 2 above). 
4.  It should be noted that this device is an intentional radiator and that any changes or modifications not 
expressly approved could void the user’s authority to operate the equipment. 
5.  Do not substitute any antenna for the one supplied or recommended by the manufacturer. The 
installer is responsible for ensuring that the proper antenna is installed. 
6.  Antenna minimum safe operating distances should be observed as stated in section 2 above. It is the 
responsibility of the qualified end-user of this intentional radiator to control the safe distances and 
exposure limits to bystanders. 
7.  DC power (+12VDC) to the unit should never be applied until the antenna (or other suitable load) has 
been attached to the device SMA RF output connector. Safe operating procedures must be observed 
when unit is transmitting into an antenna (see sections 1 & 2 above). 
8.  Electro-Static Discharge (ESD) precautions should be observed as a safe practice. 
9.  The transmitter will generate considerable heat and is the responsibility of the end user to properly 
heat sink the device before using. 










