User manual

Chapter 5: Maintenance and troubleshooting
98-143082-A Restore the settings of the EXPLORER 510 69
Restore the settings of the EXPLORER 510
The EXPLORER 510 has a restore button that has three functions: To restore all settings to
factory settings, to restore WLAN settings only or to put the EXPLORER 510 into safe mode for
recovery software upload.
The restore button is located inside the small hole next to the SIM slot.
Do as follows:
1. Loosen the two screws holding the SIM cover.
2. Lift the cover.
3. Use a pointed device to push the restore button.
4. Close the cover and tighten the two screws carefully.
This is important in order to maintain the IP grade of the EXPLORER 510.
Action Function
Push and hold the Restore
button for 2-10 seconds
WLAN settings are restored to default.
The WLAN LED lights yellow.
Default WLAN settings:
• Broadcast SSID is EXPLORER510
• Encryption standard is WPA2-AES
• Encryption key is the serial number
of the EXPLORER 510
• Region is Other, i.e. the most
restrictive setting
Push and hold the restore
button for > 10 seconds
The EXPLORER 510 restores factory
settings and reboots the system. All
changes to the configuration are lost.
While the EXPLORER 510 is
booting, push and hold the
restore button
The EXPLORER 510 enters safe mode.
Both LEDs are flashing blue.
In safe mode the EXPLORER 510 is ready
for a recovery software upload (see
Recovery software update on page 68).
Restore button