User manual

Operation
11
Other functions
Programming the Call channel
To program the Call channel, do as follows:
1. Press and hold 16/C until the current Call channel number is flashing.
2. Select the channel with  or .
3. Press 16/C to confirm within 3 seconds.
Programming the scanning memory
To add a channel to the scanning memory, select the channel and then
press and hold the SCN key until the display shows MEM at the top.
To remove a channel from the scanning memory, select the channel and
then press and hold the SCN key until the MEM sign disappears from the
display.
Low power operation
The radio can be operated in low power mode. In this mode battery life
time is dramatically increased. Up to the first second of a received call
might be lost if this mode is selected. Refer to SLEEP on page 21.
Continuous Tone Coded Squelch System
Selective squelch opening by sub-tone detection (CTCSS) can be enabled,
using the configuration mode (see CTCSS on page 24). Please note that if
the radio is operating with CTCSS on a channel, and a carrier is received,
it may not be recognized in the loud speaker if the matching sub-tone is
not detected. For this reason, be very careful not to use CTCSS
programmed channels in emergency situations. For the same reason
0845