4625 - 4627 USER MANUAL
Summary 1. INTRODUCTION .................................................................................................................................................... 4 2. ARMING AND DISARMING THE SYSTEM WITH THE ORIGINAL VEHICLE REMOTE CONTROL OR WITH THE COBRA REMOTE CONTROL .............................................................................................................................4 3. ACTIVE FUNCTIONS (functions description) .........................................................
Dear Customer, The product you’ve choosen is in line with the quality and functional standards required by the main Car Manufacturers and it complies with the safety and security European directives. The technology used for the remote controls and the Driver cards guarantees an high level of security toward attempts to reproduce the digital code.
1. - INTRODUCTION. This system is equipped with a built-in CAN interface (Controller Area Network) that allows it to detect CAN data from the electric vehicle platform. The system can be armed/ disarmed with the vehicle original remote control or with the Cobra remote control (optional). 2. - ARMING AND DISARMING WITH THE VEHICLE ORIGINAL REMOTE CONTROL OR WITH THE COBRA REMOTE CONTROL (optional).
3. - ACTIVE FUNCTIONS. 3.1 - Interior protection with ultrasonic volumetric sensor. The system protects the vehicle interior with a volumetric ultrasonic sensor. Any attempt to get into the vehicle will be detected and the alarm will trigger. 3.2 - Perimetric protection with door open warning diagnostic. 3.5 - Arming the system with the volumetric ultrasonic protection disabled. This function allows to arm the system leaving temporarily disconnected the interior volumetric protection.
3.6 - Emergency panel LED. 3.8 - Emergency disarming. The LED main scope is to show the system arming and disarming conditions. When the system is armed the LED gets ON and remains illuminated until the 25 s arming period has elapsed. After that it starts blinking. It goes OFF as soon as the system is disarmed. If the vehicle original remote control get lost or if it doesn’t work, open the door with the mechanical key and turn the ignition key ON.
4. - PROGRAMMABLE FUNCTIONS. 4.5 - Passive engine starting inhibition. 4.1 - Activation and volume adjustment of the audible arming and disarming signaling. The starting inhibition becomes active after 115 s the vehicle has been switched OFF. The starting inhibition is immediately deactivated if the Driver Card (optional) is detected or when a correct emergency PIN Code has been digit on the emergency panel. This functionality is totally independent from the other ones.
4.7 - Anti hi-jacking. This function helps to prevent the vehicle hi-jack while driving, taking care also to the safety of the driver. If the driver isn’t recognized, the system will consider him as an unauthorized person to drive the vehicle; it will generate an alert sequence and it will not allow the engine starting after it has been switched off.
4.8 - Garage mode. This function allows to temporarily disable all protection automatic functionalities of the system. It can be used, as an example, when you need to leave the vehicle at a workshop for maintenance to avoid the automatic activation of any functionality. When the garage function is active the driver is allowed to turn the ignition key on for 10 times (engine running). After 10 times the system restore all automatic functionalities. Activation - Open driver side door.
4.11 - Personalization Pin Code. www.cobra-at.com The Personal Identification Code is a four digits code which is already stored in the system. The sticker with the PIN code must be applied by the installer on the PIN code card you should have got from your installer. Keep the PIN code card always with you. The code is required to emergency override the system the remote control doesn’t work or if you’ve lost it.
5. - EMERGENCY OVERRIDE WITH PIN CODE. If the vehicle original remote control get lost or if it doesn’t work, open the door with the mechanical key and turn the ignition key ON. If the system doesn’t disarm automatically proceed as follow: press the emergency panel pushbutton for a number of times corresponding to the first digit of the PIN Code. Each pushbutton pressure is confirmed by a quick flash of the LED.
6. - COBRA REMOTE CONTROL (optional) BATTERY REPLACEMENT. The Cobra remote control battery is a CR2032-3V lithium battery. Its replacement is necessary as soon as, by pressing one of the two pushbuttons, the LED flashes irregularly or just for a short time. To replace the battery perform the following steps: • open the remote control shell, being careful to lever it up in the point indicated in the drawing. • Remove the battery as shown (dispose the empty battery in the appropriate container disposal).
7. - DRIVER CARD (optional) BATTERY REPLACEMENT. The Driver Card battery is a CR2032-3V lithium battery. When the Driver Card battery is low the emergency panel LED flashes for 10 times. If the system doesn’t disarm when the Driver Card is inside the vehicle try to disarm it by pressing the Driver Card pushbutton, otherwise replace the battery. • To change the battery, open the Driver Card shell, being careful to lever it up at the point the area indicated in the drawing.
8. - TROUBLESHOOTING GUIDE. THE REMOTE CONTROL DOESN’T ARM/DISARM THE SYSTEM. Root cause Countermeasure a. If the system is armed, perform the emergency override procedure (see step 5). The battery is empty. b. Replace the battery. For Cobra remote controls see step 6, for the original remote control follow the instructions of the vehicle “Use and maintenance” manual. c. If you cannot solve the problem contact your installer.
9. - WARRANTY CONDITIONS. This product is guaranteed for 24 months from the date of purchase, validated by receipt or invoice. The warranty will be null and void if the product shows signs of tampering, incorrect installation, damage caused by falling or transport, negligence and anything else not imputable to manufacturing defects.
The manufacturer shall not be liable for any faults or malfunctions in the anti-theft device and/or in the electrical system of the vehicle due to incorrect installation and/or to failure to comply with the indicated technical specifications. The system must only be considered as a deterrent agaist theft attempts. Cobra Automotive Technologies 06DE3631A - 05/12 via Astico 41 - 21100 VARESE - ITALY www.cobra-at.