Specifications

Installation
Installation
54
In a negative grounded vehicle, connect the
red lead of the DC power cord to an accessory
12 volt fuse.
Connect the black lead to the negative side
of the vehicle. This is usually the chassis. Any
convenient location with a good electrical
contact (remove paint) may be used.
4
5
Plug power cable into back of unit marked
“Power”. Be sure to observe polarity markings.
Mount the microphone
bracket on either side
of the unit (driver’s
left) using two screws
supplied. Bracket should
be placed under the dash
so microphone is readily
accessible.
6
7
Attach the 4-pin microphone cable to
receptacle on front of unit and Install unit in
bracket securely.
8
ANT
PA.SP. EXT.SP.
+ POWER –
SIG1 3579 +30dB
23 CAL
RF
SWR
RF
DYNAMIKE
RFGAIN
SWR CAL
S/RF
SWR
CAL
NB/
ANL
ANL
OFF
CB
PA
CH19
CH9
NOR
MIN MAX MIN
MAX
OFF
VOL SQL
DIMMER
HI
NOR
MIN MAX
RX/TX
29 NW
TONE
Note
For best performance, we
recommend the radio be
connected directly to the
battery.
Note
Before installing the CB
radio, visually check the
vehicle’s battery connection
to determine which terminal is
positive or negative.
A negatively grounded vehicle
has its negative lead grounded
to the chassis.
Note
Connecting to an accessory
fuse prevents the unit from
being left on accidentally, and
also permits operating the unit
without running the engine.
AW-1210041-1B_29NWLTD_CLASSIC_MANL REV_022021.indd 4-5AW-1210041-1B_29NWLTD_CLASSIC_MANL REV_022021.indd 4-5 2/24/21 2:57 PM2/24/21 2:57 PM