User's Manual

InstallationInstallation
Mounting and Connections
The Ju n ction Box is held by two scre ws,pe rm i t t i n g
mounting in the manner most convenient for
your installation.
Mounting hardware is supplied for mounting the
Junction Box.The mounting must be mechanically
s t rong and also provide a good elect ri cal co n n e ct i o n
to the chassis of the vehicle.Proceed as follows to
mount junction box:
Mounting and
Connections
5
Caution
Leaving the 75 WX ST on after
your car is turned off can drain
your car batte ry when co n n e cte d
to a constant 12 volt source.
When co n n e cted to an acce s s o ry
12 volt source the unit will turn
off when vehicle is turned off.
4
After you have dete rmined the most co nve n i e nt
location in your vehicle, hold the Cobra HH-75
WX ST Junction Box in the exact location
desired. If nothing will interfere with mounting
it in the desired position,use the Junction Box
as a template to mark the location for the
mounting screws.Before drilling the holes,
make sure nothing will interfere with the
installation of the mounting screws.
1
2
3
Connect the antenna cable connector to
the antenna receptacle on the unit. Most CB
antennas are terminated with a type PL-259
plug and mate with the receptacle.
For co n s t a nt 12 volt source powe r,co n n e ct
the red wire marked “ BATT ( + ) ”d i re ctly to the
po s i t i ve side of the bat te ry or to a co n n e ction
on the fuse block that is always on.
4
Co n n e ct the black wire marked “Gro u n d”to the
n e g at i ve side of the ca r,usually the chassis.Any
other location with good elect ri cal co nt a c t paint
re m oved will also wo rk .
Re m ove ru b ber grommet from metal
m o u nting plate (1).
5
Mounting and
Connections
75 WX ST Manual(5188) 2/5/01 3:00 PM Page 4