NAV7700_QSG.
Page 4 Page 7 Page 8 Page 9 Page 10 Page 11 Page 13 Page 14 Page 16 Page 18 Page 19 Page 20 Page 22 Page 23 Page 24 Page 25 Page 26 Page 27 Page 28 Page 30 Page 31 Page 32 CONTENTS Important Safety Information About the 7700 Pro System Start Up Powering the 7700 Pro using the built-in battery Instaling the 7700 Pro using the Windshield Suction Cup bracket Operating Instructions Starting Up Easy Set Up Screen Settings Brightness and Volume Control Brightness Control Volume Control Entering Vehicle informa
Important Safety Information • Before installing and using the Cobra 7700 Pro system, please read these general warnings and precautions. Without reading this important safety information, the user may be placed in a dangerous situation or may damage the unit before having any practical use from it. It is strongly recommended to read this entire manual to be familiar with the system’s features, and to know how to operate it.
CAUTION SYMBOLS AND STATEMENTS Please pay special attention to the CAUTION symbols and statements in this manual. CAUTION Statements identify conditions that could cause damage to the system or other equipment. CAUTIONS: • The user is responsible for operating this product wisely. This 7700 Pro unit is intended for use only as a navigational aid and should not be relied upon to the exclusion of other information.
To utilize the AURA™ Camera database you will need to register your 7700 Pro and perform a download. Please refer to ‘Registering your 7700 Pro, ‘System Requirements and Software Installation’ later in this Quick Start Guide for further information. Start Up 2. Powering the 7700 Pro using the built-in battery Once the 7700 Pro is fully charged, it is ready for use. Press and hold the standby/power switch on the top right side of the unit for 2 seconds to switch on the device. Power switch 1.
Operating Instructions 3. Installing the 7700 Pro using the Windshield Suction Cup bracket You can mount your 7700 Pro to the inside of your vehicles windshield using the windshield bracket provided. ● ● ● ● ● Clean the area where you wish to position the bracket thoroughly with a high quality glass cleaner. This allows a more secure seal on the windshield. Assemble the suction cup bracket. Slide the mount clip onto the end of the suction cup arm and tighten both plastic nuts.
2. Easy Set Up Screen settings - There are a number of map views or different types of information that can be displayed on the screen at any one time: 3D 2D North 89 Current time or vehicle speed MILES Distance to destination 20:33PM 0:33LEFT GPS Signal strength Press ‘OK’ at the bottom of the screen. Your chosen settings will now be saved and will appear on the screen each time you use your 7700 Pro.
Note: The arrow icon in the bottom right hand corner of the display will return you to the ‘Configure’ menu if pressed but will not store any changes you have made. You need to select the ‘OK’ button in order to save your changes. Volume Control - Press the icon. Using your finger press either the ‘+’ button to increase the volume or the ‘–’ button to decrease the volume. Finally select the ‘OK’ button to confirm the setting. 3.
4. Navigating to an address Take your 7700 Pro outside so that the GPS receiver can locate your position. When satellite lock is achieved, the screen will display your current position on its map in a ‘3D’ navigation view. Your position (and direction) is indicated by the icon. Make sure that you have the correct vehicle selected and then press . The 7700 Pro will calculate the fastest route from your current position to your destination. Tip: To reduce the ‘cold start’ GPS time remain stationary.
Tip: If you miss a turn or drive down a wrong road, a new fastest route will be calculated automatically, based on your new position and direction of travel, a tone will be heard to confirm re-routing. The 7700 Pro will always give you clear instructions that will take you to your chosen destination. 5. Navigating using the name of a town or city and road name.
● ● ● Enter the address using the keypad that is displayed. If you make a mistake when entering any field you can press the key at the bottom of the keypad to erase the data and then re-type the information. When you have entered the correct postcode press the ‘Set’ button on the keypad. The destination will now appear in the multi-route screen. Repeat the steps above to enter further destinations. Once you have entered all your destinations press ‘Save’.
10. System Security Code The 7700 Pro incorporates pin code security protection so that only users with access to the pin code can use and operate the device. To activate the security code, access the Menu by touching the center of the screen and then press the ‘Configure’ button. Next, tap the ‘System Security Code’ icon and then select ‘Yes’ to switch the function on. Press the ‘Enter Code’ button and enter the 4 digit code that you would like to use to protect your Truckmate and press ‘OK’.
BATTERY OPERATION The 7700 Pro has a built-in rechargeable battery to allow operation without a power cord attached. The battery automatically goes into Recharge mode whenever a power cord is plugged in to the unit. On a full charge, the unit will last for approximately 2 hours of normal operation while in battery mode. TROUBLESHOOTING PROBLEM POSSIBLE CAUSE(S) SOLUTION(S) Battery switch is turned Off. Turn the battery switch on the rear of the unit to ON and press the Power Button.
Specifications OS Windows CE 5.0 Storage 4GB internal memory LCD Display 7”, TFT LCD (480 x 234 pixels, anti-glare) User Interface Touch Screen Speaker Integrated 2W high quality loudspeaker Battery Rechargeable Lithium-Ion battery. 1600 mAH Power Up to two battery operating hours Operating Temperature 14° F ~ -140° F (- 10 ˚C ~ + 60 ˚C) Accessories Included: • Windshield mount • Dashboard mounting disk • 12V DC power cord • 120V AC adapter • USB cable 26 NAV7700_QSG.
USER LICENSE continued THE 7700 Pro PRODUCT IS PROVIDED ON AN “AS IS” AND “WITH ALL FAULTS BASIS” AND COBRA AND LICENSORS EXPRESSLY DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY, QUALITY, ACCURACY, TITLE AND FITNESS FOR A PARTICULAR PURPOSE.
PRODUCT SERVICE For any questions about operating or installing this new Cobra product, or if parts are missing…PLEASE CALL COBRA FIRST…do not return this product to the store. If this product should require factory service, please call Cobra first before sending the product. This will ensure the fastest turnaround time on any repair. If Cobra asks that the product be sent to its factory, the following must be furnished to have the product serviced and returned: 1.
TRADEMARK ACKNOWLEDGEMENT Cobra®, Intelligent Accelerated Satellite Acquisition Protocol (iASAP) Technology®, Nothing Comes Close to a Cobra® and the snake design are registered trademarks of Cobra Electronics Corporation, USA. AURA™, Cobra Electronics Corporation™ and SmartPower™ are trademarks of Cobra Electronics Corporation, USA. Windows® is a registered trademark of Microsoft Corporation. Tele Atlas® is a registered trademark of Tele Atlas, N.V.
