User's Manual

2
For charging microTALK
®
radio(s) in desktop
charger:
1. Insert radio(s) into desktop charger as shown.
2. Insert round connector of 120-volt adapter
into jack on back of charger.
3. Plug 120-volt adapter into electrical outlet.
If charging light is not on, check position of radio. Radio should be
upright. The charge indicator light will stay on as long as the radio
is in the charging well and the battery pack is charging. After the
battery pack is fully charged, the charge indicator light will turn off.
It normally takes about 15 hours to fully recharge battery pack.
Battery pack will not be damaged if they stay in the charging well
longer than that.
NOTE
To charge a single radio, you can bypass the desktop
charger and simply insert the wall adapter’s round
connector directly into the speaker/microphone/charge
jack located on the top of the radio.
Use only the supplied rechargeable batteries and charger for
recharging your Cobra microTALK
®
radio.
Cobra recommends your radio is turned off while being charged.
Introduction
Using Your Radio
Quick Start
1. Press and hold the Power button
to turn on your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
Both radios must be tuned to the
same channel/privacy code to
communicate.
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
Insert Radio(s)
LI7000WX.qxd:9813-LI6000 vB 9/29/06 11:40 AM Page 2