User's Manual

Nothing comes close to a Cobra
®
Advanced Operation
51
50
English
Advanced Operation
During Scanning (While Not Receiving A Transmission),
You Can Choose From The Following:
a.
Press the Talk button to communicate on the last Tri-Watch location
scanned and return to
Standby mode.
b. Press the Up/Down buttons to change the scan direction.
Scan
Memory Scan mode is similar to the Tri-Watch mode except that it
will scan as many channels as you choose.
NOTE
The radio must be Squelched for the Memory Scan mode to function.
See page 36 for
Squelch procedure.
Memory Channels
You can program (or tag) any or all channels to be scanned in the Memory Scan
mode. These tagged channels can be scanned using Memory Scan mode.
To Program Memory Channels:
1.
Select a channel to be tagged using the Up/Down buttons.
2. Press and hold the Memory Scan/Memory Clear button
for three (3) seconds. The channel will be tagged for
scanning and
MEM (Memory Channel) will appear next
to the channel number on the LCD whenever that channel
is selected.
The radio will return to
Standby mode as soon as the
Memory Scan/Memory Clear button is released.
Repeat steps 1 through 2 to tag as many more channels
as you wish.
To Clear Memory Channels:
1.
Select a channel to be cleared from a memory
tagging using the
Up/Down buttons.
2. Press and hold the Memory Scan/Memory Clear
button for three (3) seconds. The channel will be
untagged and
MEM (Memory Channel) will no longer
appear next to the channel number on the LCD
whenever that channel is selected.
The radio will return to
Standby mode as soon as
the
Memory Scan/Memory Clear button is released.
Repeat steps 1 through 2 to clear additional channels
from memory locations.
Memory Scan
During Memory Scan, the radio will rapidly switch from tagged channel to tagged
channel. Whenever any activity is detected, the radio will stop the scan for ten (10)
seconds to allow you to listen briefly on that channel. It will then continue to scan
unless you switch out of the
Scan mode.
NOTE
If there are fewer than two (2) channels tagged, the Memory Scan mode
will not be available. [See “To Program Memory Channels” to tag at least
two (2) channels.]
To Enter Memory Scan:
1.
From Standby mode, press the Memory Scan/
Memory Clear
button.
The radio will immediately begin to scan the channels you
tagged.
MEM SCAN (Memory Scan) will show on the LCD.
To Exit Memory Scan:
1.
From Memory Scan mode, press the Memory
Scan/Memory Clear
button.
2. This will return the radio to Standby mode on
the last scanned memory location.
Operating Your Radio Operating Your Radio
Up/Down Buttons
Up/Down Buttons
Memory Scan/Clear
Memory Channel
Memory Channel
Memory Scan/Clear
Memory Scan/Clear
Memory Scan Mode
Is Subhead appropriate?
Please advise on
screen illustration
to pick up.
Is Subhead appropriate?
Please advise on
screen illustration
to pick up.
Please advise on
screen illustration
to pick up.