User's Manual Part 1

Ù Ú
Û Ü
Ý Þ
Ü ß
à
Ü
á
â
Ú ã ä å
Þ
Ü ß
æ ç
ä
è é á Þ
Ú
² ³ ´ µ ¶ · ¸ ¹ º
» ¼ ½
¹ ¾ º
½ ¼
¿ º
À
¹ º Á Â
À
à Ä
. Ä /
Ç · ¸ È ¶ É µ
Ê Ë Ì Í Î Ï Ï Î Í Ð Ñ Ë Ò Ë Ó Ô Í Î Õ Í Ö × Ø Ê Ë Ì Í Î Ï Ï Î Í Ð Ñ Ë Ò Ë Ó Ô Í Î Õ Í Ö × Ø
Ù
Ú Û Ü
Ý Þ
Ü ß
à
Ü
á
â
Ú ã ä å
Þ
Ü ß
æ ç
ä
è é á Þ Ú
NOTE
All wiring is best kept as short as possible. If the power leads must be
extended, use a high-quality, marine-grade cable sized for up to 10 amps
of current. To minimize voltage drop, choose a wire gauge as follows:
Length Wire Gauge
Up to 1.5m(4.9ft) 1.6 mils(#14)
Up to 3.0m(9.8 ft) 2.0 mils(#12)
Up to 5.0m(16.4 ft) 2.6 mils(#10)
Up to 6.0m(19.7 ft) 3.3 mils(#8)
0
ï ö ì
ñ ì
ò
ù î ñ
û

ü ö
FCC regulations require that the Warning Sticker
supplied with this radio be applied to a spot where
it is easily seen by the radio operator. Be sure the
location is clean and dry before applying the sticker.
1 ð
ü û
î
ö
ñ
û ï
ð 2
ô 3 ü ö
4
ô ì ì ü û
î ñ
ô ì
Your CobraMarine VHF radio is powered
from +10.0V to +16.0V vessel direct
current electrical, negative ground
systems (12-volt nominal). A fused
power connection lead is provided at the
back of the transceiver.
To Connect To A Power Source:
1. Attach the black (-) wire to a negative
(-) ground.
2. Attach the fused red power (+) wire
to the positive (+) side of the power
system.
NOTE
This radio will draw up to 8 amps when transmitting at full power.
NOTICES
A reverse polarity connection will damage the radio.
When replacing the fuse in your transceiver, use only the size and type
originally provided.
5 Î Õ Ë Ð Ë  Ô Í Ð    Õ
6 Ñ   Õ 7 Ñ Ë Ë   Í Ð Ñ Ë 7 Î  Ï  Ì
Red Cable
Positive (+)
Black Cable
Negative (-)
8 9
             !    " # $ % % & : ( & ; ) * & ' * ) + ) & , & & - 