User's Manual Part 1

 J
K L
M
N O P Q
       

  
 
To Select the Coordinate System:
1. Enter the Settings menu and scroll to
GPS MENU
with the Up/Down soft keys or the Up/Down channel
buttons.
2. Highlight the
COORDINATE SYSTEM option in the menu.
3. Press the ENTR key and observe the current setting.
4. Use the Up/Down soft keys or the UP/Down channel
buttons to change the setting to use the desired
coordinate system.
5. Press the ENTR soft key to select the setting. Or press the
EXIT soft key to
EXIT without making changes to the
Coordinate System setting.
6.
The radio will return to the GPS menu. The radio will
remember the saved Coordinate System setting, when
powering off the radio, or disconnecting power to the radio.
To Select the Coordinate System:
1. Enter the Settings menu and scroll to
GPS MENU
with the Up/Down soft keys or the Up/Down channel
buttons.
2. Highlight the
COORDINATE SYSTEM option in the menu.
3. Press the ENTR key and observe the current setting.
4. Use the Up/Down soft keys or the UP/Down channel
buttons to change the setting to use the desired
coordinate system.
5. Press the ENTR soft key to select the setting. Or press the
EXIT soft key to
EXIT without making changes to the
Coordinate System setting.
6.
The radio will return to the GPS menu. The radio will
remember the saved Coordinate System setting, when
powering off the radio, or disconnecting power to the radio.
Æ Ç È É Ê Ë Ì Í Î Ï Ð Ñ É Ò Ê Ó Ì Ð
       

  
  
       ¡
¢ £ ¤
 ¥ ¡
¤ £
¦ ¡
§
 ¡ ¨ ©
§
ª
 R
Æ Ç È É Ê Ë Ì Í Î Ï Ð Ñ É Ò Ê Ó Ì Ð
ì Ð í Ë î È ï Û
× Ç Ø Ù Ð Ú Í Ö Ñ Ë Ë Ð Í Û
S T U V S W V X
Y Z Z X [ U W \ V S ] ^ ] V S _
[ [ [ _ _ ` _ _
[ [ [ _ _ ` ] ]
[ [ [ _ _ ` _ _ _
aaa
b 0 ² ¹
³ ¶ º
All VHF Marine radios SHOULD / NEED to have a GPS receiver connected and operating
to effectively use the DSC (Digital Selective Calling) features built-in to the radios.
In an Emergency you want the rescue authorities and surrounding vessels to know
where you are and to be able to quickly assist you in your time of need.
This menu allows you to select the coordinate system which is basically the
accuracy (the most accurate setting is selected by default), and allows you to test
the GPS receiver, select the coordinate system which is basically the accuracy (the
most accurate setting is already selected by default), Select the Satellite Based
Augmentation System to be enabled or turned off (some areas on Earth need this
turned off for greater accuracy)(defaulted On), and allows you to test the GPS receiver
(will test either the internal or an external GPS receiver) to be sure that you are
receiving good satellite information and check the GPS signal strength.
ö ÷ ø ù ú û ö ü ý þ û ÿ   ÷ ü   ÿ ý

    . c  . ù       ù    ù  ü ö