User's Manual

Nothing Comes Close to a Cobra

Advanced Operation

Memory Location Scan

During Memory Location Scan mode, the radio will rapidly

scan through all pre-assigned memory channels. Whenever

any activity is detected on a channel, the radio will stop the

scan for 10 seconds to allow you to listen briefly on that

channel. It will then continue to scan unless you switch out

of Memory Location Scan mode.

NOTE

The radio must be squelched for the Memory

Location Scan mode to function. See page 40 for

Squelch procedure.

NOTE

If there are fewer than two (2) Memory locations

programmed in the radio, the Memory location scan

option will not be available. To program at least two

(2) memory locations, see page 66.

To Enter Memory Location Scan:

1. From Marine or GMRS Standby mode, press the

MEM/ESC button.

2. Press the SCAN button. The radio will immediately

begin to scan all pre-assigned memory channels.

The SCAN and MEM icons will show on the LCD.

3. A signal on any channel will stop the scan for 10

seconds to allow you to listen to the traffic on that

location.

NOTE

After the Memory Location Scan stops to monitor a

channel, as long as you do not press any buttons within

10 seconds, your radio will automatically resume

scanning the Memory Location Scan channels.

4. Press the Channel Up/Down button to resume

scanning the Memory Location Scan channels or to

change the scan direction.

5. To EXIT Memory Location Scan mode, press the

SCAN button again. The SCAN and MEM icons will

disappear from the LCD and the radio will return to

Marine or GMRS Standby mode.

Memory Location Scan

MEM/ESC Button

SCAN Button

Operating Your Radio

MRHH425VP-Body-Eng.qxp:400_Body 10/26/06 1:38 PM Page 69