User's Manual

English

Introduction

Setup Mode Programming

•

The following series of procedures is designed to allow you to set the programmable

features of your radio. Correctly following these steps results in a minimal amount

of radio setup programming time.

NOTE

When in any of the Setup modes (Marine (VHF), GMRS or WX Alert), if you

stop programming for longer than 15 seconds, your entry will be saved and

the radio will go back to the specific Standby mode that you were in when you

started programming. When you return to Setup mode and continue

programming you will see the last “value” displayed. While in any Setup mode,

you will not receive any signal reception.

Programming these features will allow you to customize certain features of this

radio to enhance your “On-Water” audio needs.

Start from Marine Standby mode to begin Marine (VHF) Setup programming. Press

and hold the Call/Enter/Setup button for two (2) seconds to enter the programming

mode.

Marine (VHF) Mode Programming

Operating Your Radio

MRHH425VP-Body-Eng.qxp:400_Body 10/26/06 1:37 PM Page 44