User manual

WASPcam™ 9907 4K User Manual
01 June 2016 Page 9
Basic Camera Functions
Installing the Micro SD Card
To insert the SD card
 With the camera off open the back cover
 Slide the silver card lock down and gently pull up
 Place the SD card in the slot
 Close and push the card lock up to secure the card in place
**Note – Please use a minimum speed Class 10 card, maximum 64GB storage capacity
Follow these steps in reverse order to remove the SD card
**Note - Please ensure that the SD Card is inserted in the correct direction or you may
damage the SD card and/or SD card reader.
Using the Wi-Fi Button
Press the Wi-Fi button to turn on the camera’s Wi-Fi. Press the button again to turn off
the camera’s Wi-Fi.
Charging the Battery
Connect camera and power supply using the included USB cable. The red indicator on the
left side on the back of the camera will remain on while the camera is charging. Once it is
fully charged the red indicator light will turn off. When plugged into a power source, the
camera will turn on and off, and then begin charging. The camera can be turned back on to
record while charging.
**Note - To improve the charging efficiency of the camera, please turn the camera off while
it is charging
Turning the Camera On/Off
To turn on the camera, press the power button for 3 seconds. A chime will sound, the
WASPcam™ 9907 4K LCD screen will turn on and the red indicator light at the front of the
camera will also turn on. To turn off the camera, press the power button again for 3 seconds
until the chime sounds and the screen goes black.