User's Manual

Appendix
34
English
NOTE
Factory defaults are highlighted in
light gray. See referenced pages for
more information on the modes.
* Not shown if IntelliMute is off. Complete
instructions for IntelliMute setup are shown
on the referenced page.
Mode Tone
Visual
Display
Voice
Set City
mode
default
Page 14
Two
beeps
City X
One
beep
City
X, K
One
beep
City X
Beep
Off
Set
IntelliMute
mode
Page 15
Two
beeps
Intelli
Mute
Off
One
beep
Intelli
Mute
On
Set
IntelliMute
setup*
Page 15
Two
beeps
Set
Engine
Revs
Mode Tone
Visual
Display
Voice
Set
AutoMute
mode
Page 16
Two
beeps
Auto
Mute
On
One
beep
Auto
Mute
Off
Set Voice
or Tone
mode
Page 16
None Voice
Alert
None
Tone
Alert
Set
Compass
mode
Page 17
Two
beeps
Compass
Off
One
beep
Compass
On
Set
Compass**
Page 17
Two
beeps
Set
Compass
** Not shown if Compass is off. Complete
instructions for calibrating the Compass
are shown on the referenced page and
on the separate insert.
User Programming Menu Guide
Appendix
Installation
Your Detector
Nothing Comes Close to a Cobra
®
3
Installation
•
Where to Mount Your Unit
You will get optimum performance from your detector if you mount it at a
point approximately in the center of the vehicle, as low as possible on the
front windshield without obstructing the unit’s view of the road either to
the front or rear. You can also mount it directly on the dashboard.
The unit’s lens must not be blocked and the LaserEye should have a clear view
out the back window to allow 360° detection.
Radar and laser signals pass through glass but not through other materials
and objects. Objects that can block or weaken incoming signals include:
■
Windshield wiper blades
■
Mirrored sun screens
■
Dark tinting at the top of the windshield
■
Heated windshields currently available on some vehicles
(Instaclear for Ford, Electriclear for GM). Consult your dealer
to see if you have this option.
The LaserEye Should Have a Clear View
Windshield Mounting Dashboard Mounting
Spreads.qxd 11/9/07 12:19 PM Page 3