User Manual
3
Installation
Your new Road Scout comes with our latest EZ Mag Mount
™
. Simply slide the Road Scout onto the
mounting bracket fully and that’s it. To remove the Road Scout from the mount, simply pull the device o
the mount.
Mounting Tips:
• Center of windshield between driver and passenger.
• Ensure clear view of road ahead and sky above.
• Avoid windshield wipers and heavily tinted areas.
To mount the Road Scout in your vehicle:
1 Remove backing from EZ Mag Mount.
2 Firmly press EZ Mag Mount onto windshield and ip locking clamp to secure.
3 Tilt the display end of the Road Scout slightly upward and engage with the mounting bracket.
The EZ Mag Mount™ magnet holds the device rmly in place.
4 To adjust view, loosen thumb wheel and adjust angle of mounting bracket. Tighten thumb
wheel to secure.
5 To remove the Road Scout, simply lift the display end of the detector upward. The device will release
from the mount.
6 To remove mount from windshield, release locking clamp and pull tab on top of EZ Mag Mount.
EZ Mag Mount Care Instructions:
To clean your EZ Mag Mount, simply rinse under warm water, gently wipe o any debris and allow
to air dry.