Specifications

InstallationInstallation
54
Note
Connecting to a fuse circuit
controlled by the ignition switch
prevents the unit from being left
on accidentally,and also
permits operating the unit
without running the engine.
Note
In positive earth vehicles the red
wire goes to the chassis and the
black wire is connected to the
ignition switch.
In a negative earthed vehicle,connect the red
lead of the DC power cord to an accessory 12
volt fuse.
Connect the black lead to the negative side of
the vehicle.This is usually the chassis.Any con-
venient location with a good electrical contact
(remove paint) may be used.
4
5
Plug power cable into back of unit marked
“Power”. Be sure to observe polarity markings.
Mount the microphone
bracket on the right side
of the unit (nearer the
driver) using two screws
supplied.Bracket should
be placed under the dash
so that microphone is
readily accessible.
6
7
Attach the 6-pin microphone cable to recepta-
cle on front of unit and Install unit in bracket
securely.
8
Note
Before installing the CB radio,
visually check the vehicle’s
battery connection to deter-
mine which terminal, positive
or negative, is earthed to the
engine block (or chassis). A
negatively earthed vehicle
has its negative lead earthed
to the chassis.
GR25LTDST-English copy 6/21/99 11:59 AM Page 4