Operation Manual
Operating Your Cobra PhoneLynx™
Plug It In
1. Plug the power adapter plug (1) into the power port of the PhoneLynx (2).
2. Plug the power adapter cord into a 110/120-volt household wall outlet.
3. Plug the phone line (3) coming from the phone, not from the wall jack, into the
transmitter.
1
2
3
⁄ WARNING
Never connect the PhoneLynx to the telephone company land
line. Only your home/ofce phone should connect to the PhoneLynx.
4. When the unit is rst powered on, the transmitter will beep twice and both
buttons will be illuminated in red.
Keep away from 2.4 GHZ wireless home phones to avoid potential
interference. Keep a reasonable distance between the base and PhoneLynx.
Pair with Cell Phone
5. Hold in either one of the buttons for three seconds. The LED for that button will
begin to blink with a blue light once per second. This indicates the PhoneLynx
is waiting to pair with your cell phone via Bluetooth
®
wireless technology.
PhoneLynx
BT215-1
PhoneLynx
BT215-2
6. Search for a new Bluetooth-enabled device on your cell phone.
7. When your cell phone nds the device, it will read “PhoneLynx BT215-1” or
“PhoneLynx BT215-2,” depending on what button was pushed.
8. When prompted for a password on your cell phone, enter “
” in the
password eld.
9. When your cell phone is paired, the PhoneLynx will beep twice and the blue
LED will slowly blink once every four seconds. The system is now ready.
NOTE: To add another cell phone, push the other button and repeat the
pairing procedure.
Go
10. Make and receive calls on your home/ofce phone just as you normally would.
You will hear a dial tone provided by the PhoneLynx when picking up the
receiver.
Cobra_PhoneLynx_SPA_FRE.indd 2 7/1/10 4:43 PM