Colour Control4 Order Code: Control4 www.cobrainternational.
User Manual COBRA Colour Control 4 Dear Customer, Thank you for purchasing the COBRA Colour Control 4. Cobra is one of the leading manufacturers of professional equipment and has decades of experience in design and production. To meet all your requirements, this unit has been designed and built to the highest of standards so you can be assured you have made a good investment. Please read this manual fully for your safety and to take full advantage of the COBRA Colour Control 4.
Protection from Fire: 1. Do not place near sources of heat. 2. Do not block any ventilation holes. 3. Check your AC wall socket will take the load you are applying to avoid any overloading. 4. Make sure you are using the correct voltage DC power supply, set to the correct polarity. Protection from Injury and Damage: 1. Never try to modify this unit. 2. Always install the unit in a suitable location where vibrations to the unit are avoided. 3.
1 2 3 9 10 11 4 5 6 7 8 12 13 14 15 16 17 18 19 Controller Front: 1. Fixture buttons and LED indicators 1-4: Use fixture button 1-4 to select a fixture. 2. Scenes buttons and LED indicators 1-8: Push a scene button to activate a scene. 3. Chase buttons and LED indicators 1-8: Push a chase button to activate a chase. 4. Red fader: Use the fader to manually set the intensity of the colour red. 5. Green fader: Use the fader to manually set the intensity of the colour green. 6.
20 21 22 23 Controller Rear: 20. DMX Polarity Switch. 21. DMX OUT 22. DC power 23. ON/OFF First Time Operation: 1. Remove all packaging materials. 2. Connect a DMX cable from the controller to the first light, then from the first light to the second. Do this until all four lights are connected to the controller. 3. Plug the controller in to the mains using the supplied AC/DC power supply then plug your four LED lights in to the mains. 4.
Play Scenes: 1. Deselect all fixtures. All LEDs next to the 4 fixture buttons must be OFF. 2. Select the correct page by pressing the Page button. 3. To select the desired scene press the Scene button. 4. Scenes can be stored on 2 pages. Each page contains 8 scenes. **Multiple scenes can be mixed together** By pressing the Page button between 1 & 2 you can see which scenes are still active on which page. The LEDs will be lit on the active scenes. Delete a Scene: 1.
. If you want to add additional steps, repeat 4, 5 & 6 until you have added all the desired steps in your entire chase. 8. Exit Record Mode. **There are maximum of 99 steps in 1 chase. 16 chases can hold a maximum of 392 steps** Delete a Step from an Existing Chase: 1. Enter Record Mode by pressing the Record button. 2. Select the chase from which you want to delete a step. 3. Use the Mode/Up and Patch/Down buttons to scroll through the chase and select the step you want to delete. 4.
Fixture 1 Red: Green Blue Master CH1 CH2 CH3 CH4 Fixture 2 Red CH9 Green CH10 Blue CH11 MasterCH12 Fixture 3 Red CH17 Green CH18 Blue CH19 MasterCH20 Fixture 4 Red CH25 Green CH26 Blue CH27 MasterCH28 Unpatch Channels: 1. Press and hold the Patch button for 3 seconds. 2. Select the fixture by pressing the Fixture button 3. Press and hold the TAP/SYNC button. Now press the corresponding scene button that you want to unpatch. Scene buttons 1-8 are DMX channels 1-8. 4.
