Operation Manual

Fig. 3

Fig. 4



Special instructions for splitting logs:

 Preparations:

The

gs t

be split should be cut to the maximum dimensions

(520 mm long, ∅ 50 – 250 mm). Ensure also that the logs are

cut straight and square.

Place the log properly on the log splitter, so as not to cause

any risk of stumbling or falling to the operator.

Bleeding

Open the bl

eed screw 3 – 4 complete turns – Fig. 5.

Close the bleed screw again when you are finished splitting

logs.

Fig. 5

Bleed screw

tighten

open (bleeding)

 Splitting logs:

¾ Alw

ys p

lac

e the logs lengthwise and flat on the main

frame of the log splitter. The log must be enclosed by the

log guide plates

. Fig. 6

Fig. 6

¾ Never pl

ace the log on the frame at an angle. Fig. 7

Fig. 7

¾ Always e

nsure that the splitting wedge and the log ram

contact the ends of the log at right-angles.

¾ Never try to split two logs at once.

¾ Never try to remove or replace the log during the splitting

process.