MODEL: M46SPH COBRA LAWN MOWER OWNER’S MANUAL Cobra Garden Machinery Henton and Chattell Ltd., London Road, Nottingham NG2 3HW UK www.cobragarden.co.
CONTENTS SECTION 1 SYMBOLS MARKED ON THE PRODUCT………………………….. 3 SECTION 2 GENERAL SAFETY RULES………………………………………….. 3 SECTION 3 PARTS DESCRIPTION………………………………..…………….… 5 SECTION 4 TECHNICAL DATA…………………………………………………...… 6 SECTION 5 ASSEMBLY……………………………………………………………… 7 SECTION 6 OPERATION INSTRUCTIONS……………………………………..… 8 SECTION 7 MAINTENANCE INSTRUCTIONS ……………………………..……. 11 SECTION 8 LUBRICATION INSTRUCTIONS ……………………………………. 11 SECTION 9 CLEANING………………………………………………………….…...
WARNING: For your own safety please read this manual before attempting to operate your new mower. Failure to follow instructions can result in serious personal injury. Spend a few moments to familiarise yourself with your mower before each use. 1. SYMBOLS MARKED ON THE PRODUCT Fig. A B.1 Read Operator's Manual. B.2 Keep bystanders away. B.3 Pay attention to the operator's hands and feet to avoid injury. B.4 Fuel is flammable, keep fire away. Do not add fuel with running machine. B.
Training 1. Before using the lawnmower read the instructions carefully. Familiarise yourself with the controls and pay particular attention in learning how to stop the machine in an emergency. 2. Never allow children or people unfamiliar with these instructions to use the lawn mower. Local regulations can restrict the age of the operator. 3. Never mow while people, especially children or pets are nearby. 4.
16. 17. 18. 19. Do not start the engine when standing in front of the discharge chute. Never put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times. Always ensure the engine is fully switched off before picking up/carrying the Lawnmower. Stop the engine and disconnect the spark plug wire, make sure that all moving parts have come to a complete stop and, where a key is fitted remove the key, make sure engine has had time to cool.
3. PARTS DESCRIPTION 1. Upper handle 2. Starter handle 3. Rope Guide 4. Locking Lever 5. Grass catcher 6. Height adjusting lever 7. Oil Cap 8. Deck 9. Spark Plug 10. Fuel cap 11. Cable clamp 12. Choke Lever 13. Brake control handle 14. Self-drive control handle Including A: Spark plug wrench Fig.L 4. TECHNICAL DATA Model M46SPH Enginetype GCV 135E Self-Propelled Yes Engine Displacement 135 cm³ Blade Width 460mm Rated Speed 2800/min Fuel Tank Capacity 0.
5. ASSEMBLY 5.1 FOLDING HANDLES 1. Fix the lower handlebars into the mower body with a suitable spanner. (Fig.1J/Fig.1K/Fig.1L) 2. Lift the two locking levers to release the upper handlebars for folding. (Fig. 1M) 3. Push the locking lever closed to lock the handlebars in the operating position. (Fig.1N) 4. Adjust the tension by turning the lock nut with a suitable spanner. (Fig.1O) 5. Attach the cable-clamp to the position shown and then attach the cable. (Fig.1P) Fig.1J Fig.1K Fig.1N Fig.1O Fig.
Apply outward pressure to disengage the lever from rack. Move the lever forward or back to adjust the height. (See Fig.5 and see clause 7.9) Fig. 5 6. OPERATING INSTRUCTIONS 6.1 BEFORE STARTING Service the engine with petrol and oil as instructed in the separate engine manual packed in your mower. Read instructions carefully. WARNING! Petrol is highly flammable. Store fuel in containers specifically designed for this purpose.
Fig.8A Fig.8B Fig. 8E Fig.8C Fig. 8F Fig.8D Fig.8G Start the engine carefully according to instructions and with feet well away from the blade. Do not tilt the lawn mower when starting the engine. Start the mower on a level surface, free of high grass or obstacles. Keep hands and feet away from the rotating parts. Do not start the engine when standing in front of the discharge opening. 6.3 OPERATION PROCEDURES During operation, tightly hold the brake handle with both hands.
CAUTION: your mower is designed to cut normal residential grass of a height no more than 250mm. Do not attempt to mow through unusually tall dry or wet grass (e.g., pasture) or piles of dry leaves. Debris may build up on the mower deck or contact the engine exhaust presenting a potential fire hazard. 6.
Fig.12B 1. Stop the mower and disconnect spark plug cable before changing the mower cutting height. 2. The central height adjustment lever offers you 10 different height positions. 3. To change the height of cut, squeeze the adjuster lever towards the wheel, moving up or down to the selected height. (Fig.12B) All wheels will be in the same height of cut. 7. MAINTENANCE INSTRUCTIONS SPARK PLUG Use only original replacement spark plug. For best results, replace the spark plug every 100 hours of use. 8.
Fig.13A Fig.13B 9.2 CUTTING BLADE CAUTION: Be sure to disconnect and ground the spark plug wire before working on the cutting blade to prevent accidental engine starting. Protect hands by using heavy gloves or a rag to grasp the cutting blades .Tip the mower as specified in separate engine manual. Remove the hex bolt and washer which holds the blade and blade adapter to the engine crankshaft. Remove the blade and adapter from the crankshaft.
cleaner should be serviced. To service the air cleaner, refer to the separate engine manual packed with your unit. The spark plug should be cleaned and the gap reset once a season. Spark plug replacement is recommended at the start of each mowing season; check engine manual for correct plug type and gap specifications. Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to permit proper air circulation, which is essential to engine performance and life.
11. TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine does not Throttle choke not in the correct position Move throttle choke to the correct position start. for the prevailing conditions. Fuel tank is empty. Fill the tank with fuel: refer to the ENGINE MANUAL. Air filter element is dirty. Clean air filter element: refer to the ENGINE MANUAL Spark plug loose. Tighten spark plug to 25-30Nm. Spark plug wire loose or Install spark plug wire on spark plug. disconnected from plug.
12. WARRANTY This product is warranted in accordance with legal regulations for a 24 month period effective from the date of purchase by the first user. This product will not be covered if used in a commercial application.
14. EC-DECLARATION OF CONFORMITY EC Declaration of Conformity We herewith declare, Cobra Garden Machinery Henton & Chattell Ltd, London Road, Nottingham NG2 3HW UK That the following machine complies with the appropriate basic safety and health requirements of the EC Directive based on its design and type, as brought into circulation by us.