Owner's Manual
Table Of Contents
- Owners Manual
- Table of Contents
- Features
- Supplied Accessories
- Parts & Controls
- Safety
- Recommendations For Marine Communication
- VHF Marine Radio Procedures
- Voice Calling
- Digital Selective Calling
- Maritime Mobile Service Identity
- Radiotelephone Calls
- Emergency Messages And Distress Procedure
- Included In This Package
- Accessories Order Info
- Mounting And Powering The Radio
- Antenna Requirements And Attachment
- External Devices And Connections
- Getting Started
- Set-Up Routines
- Digital Select Calling (DSC) Setup
- Advanced Operation
- Maintenance
- Troubleshooting
- Specs
- VHF Marine Channel Assignments
- Weather Channel Assignments
- World City Time Zones
- Flush Mount Template
- Note on Incorrect Wire Colors Listed in Manual
- Warning Sticker
- Warranty
Nothing Comes Close to a Cobra
®
17
Microphone Bracket
To Install The Microphone Bracket:
1. Install the microphone bracket
on a vertical surface near the transceiver
using the supplied stainless steel screws.
Flush Mount
A Flush Mounting kit is included with your CobraMarine
VHF radio to allow its installation in almost any flat surface.
To Mount The Transceiver Flush In Almost Any Flat Surface:
1. Use the supplied template to mark and cut an opening
in the flat surface. See page 85 for template.
CAUTION
Before cutting, be sure the area behind the flat
surface is clear of any instruments or wires that
might be damaged in the process.
2. Insert the transceiver into the opening.
3. Attach the flush mounting brackets to the sides of the
transceiver with the adjusting screw flanges facing
the back of the flat surface.
4. Tighten the adjusting screws against the back of the flat
surface until the flange on the front of the transceiver
is tight against the flat surface.
Installation And Start-Up
Mounting And
Powering The Radio
Use Supplied Template
Insert Transceiver
Adjust Screws
See page 85
for template.
Microphone Bracket