Owner's Manual
Table Of Contents
- Owners Manual
- Table of Contents
- Features
- Supplied Accessories
- Parts & Controls
- Safety
- Recommendations For Marine Communication
- VHF Marine Radio Procedures
- Voice Calling
- Digital Selective Calling
- Maritime Mobile Service Identity
- Radiotelephone Calls
- Emergency Messages And Distress Procedure
- Included In This Package
- Accessories Order Info
- Mounting And Powering The Radio
- Antenna Requirements And Attachment
- External Devices And Connections
- Getting Started
- Set-Up Routines
- Digital Select Calling (DSC) Setup
- Advanced Operation
- Maintenance
- Troubleshooting
- Specs
- VHF Marine Channel Assignments
- Weather Channel Assignments
- World City Time Zones
- Flush Mount Template
- Note on Incorrect Wire Colors Listed in Manual
- Warning Sticker
- Warranty
22
English
External Devices
And Connections
External Devices And Connections
•
Your CobraMarine VHF radio is set up to connect auxiliary devices for navigation,
convenience, and added versatility. As is the case with the antenna, choosing these
devices is best done with the advice and guidance of a knowledgeable dealer.
Standard connectors are provided on the front and back of the transceiver.
External Speaker (Not Included)
An External Speaker can provide greater volume to hear messages than the speaker
incorporated in the CobraMarine microphone/speaker.
To Install An External Speaker:
1. Connect the wires to the External Speaker as follows:
Orange wire - +Positive connection
Black wire - -Negative connection (Black wire is common shared -Negative for
the External Speaker and PA output)
2. Make sure to solder, crimp, or twist the wires together firmly and use shrink
tubing or electrical tape to waterproof the connection.
Public Address Speaker (Not Included)
At times, it may be handy to hail other boats or give instructions to line handlers
on the dock. Your CobraMarine VHF radio can be switched to operate in the Public
Address mode through an attached PA speaker.
To Install A Public Address Speaker:
1. Connect the wires to the External Speaker as follows:
Red wire - +Positive connection
Black wire - -Negative connection (Black wire is common shared -Negative for the
External Speaker and PA output)
2. Make sure to solder, crimp, or twist the wires together firmly and use shrink
tubing or electrical tape to waterproof the connection.
Installation And Start-Up
Wiring Located at Back
of Radio
Wiring for External and
Public Address Speakers