Owner's Manual
Table Of Contents
- Owners Manual
- Table of Contents
- Features
- Supplied Accessories
- Parts & Controls
- Safety
- Recommendations For Marine Communication
- VHF Marine Radio Procedures
- Voice Calling
- Digital Selective Calling
- Maritime Mobile Service Identity
- Radiotelephone Calls
- Emergency Messages And Distress Procedure
- Included In This Package
- Accessories Order Info
- Mounting And Powering The Radio
- Antenna Requirements And Attachment
- External Devices And Connections
- Getting Started
- Set-Up Routines
- Digital Select Calling (DSC) Setup
- Advanced Operation
- Maintenance
- Troubleshooting
- Specs
- VHF Marine Channel Assignments
- Weather Channel Assignments
- World City Time Zones
- Flush Mount Template
- Note on Incorrect Wire Colors Listed in Manual
- Warning Sticker
- Warranty
Nothing Comes Close to a Cobra
®
27
c. To listen to the Weather Radio press the WX (Weather)
soft key. This will activate the weather radio mode. When
in the Weather mode, the Up/Down buttons will change
the weather channel.
d. Press and release the Back softkey to return the radio to
Standby Mode.
HI/LO Transmit Setting
•
Transmit Power Output
Your radio can Transmit selectively at one (1) or 25 watts of power. Cobra
®
suggests
you maintain the low power setting for short-range communications and to avoid
overpowering nearby stations with your signal. Use the high power setting for long-range
communications or when you do not receive a response to a signal sent at one (1) watt.
To Toggle Between The High And Low Power Modes:
1. Press the High/Low Power button. The LCD will show which
mode is in effect.
Some channels are restricted to use at a maximum of one
(1) watt. Your radio will automatically set the power to Low
Power mode when you select those channels.
While using the U.S.A. channel map, if, in an emergency,
you need to increase the output power on Channel 13 and
Channel 67 for your signal to be heard, you can override the
Low Power mode by pressing and holding the High/ Low
Power button.
Transmit a Message
1. Check to see that your unit is set to a proper channel for the
type of message you plan to send.
2. Toggle to the low power setting.
3.
With the microphone about two (2) inches [five (5) cm] from
your mouth, press and hold the Talk button and speak into
the microphone. Transmit will be indicated on the LCD.
4.
Release the Talk button when you are finished speaking. Your
unit can only operate in either the Transmit or the Receive
mode at any given time. You will not hear the response to your
message unless the Talk button is released.
NOTE
If the Talk button is held down for five (5) minutes, the radio will
automatically cease transmitting to prevent unwanted signal generation.
As soon as the Talk button is released, it can be pressed again to
resume transmission.
Weather Button
Getting Started
Operating Your Radio
High/Low Power Button
TW CALL SCAN more
emerg
no gps Data
1WUSA