Installation Guide
Table Of Contents
- 1. About this Manual
- 2. Product Overview
- 3. Radio Node Model
- 4. Connectors, SFP+ and Micro-USB Ports, and Status LED
- 5. System Specifications
- 6. Compliance
- 7. Mounting the Radio Node
- Always consult and follow local codes for mounting and wiring Corning equipment.
- 7.1 Flush Mounting the SCRN-510
- The security screws should not need to be adjusted but if they do, loosen them slightly to be able to slide the ceiling-mount bracket on and off.
- The shoulder screws should not need to be adjusted but if they do, loosen them slightly to be able to slide the ceiling-mount bracket on and off.
- Corning recommends that you use a customer-supplied projector mount when hanging the SCRN-510 from a dropped T-bar ceiling.
- 7.2 Downtilt Mounting the SCRN-510
- 8. Cabling Guidelines
- 9. Completing the Installation
- 10. Detaching the Radio Node from the Mounting Brackets
- 11. Radio Node LED Boot Sequence
- 12. Radio Node LED Management
- 13. Corning Documentation Set
Corning Restricted and Confidential Proprietary - Controlled content
SCRN-510 Hardware Installation Guide | DOC-SCRN-510-HIG_i4 | 16 October, 2020 | Page 4
Table of Contents
FCC Statement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Other Cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Section 1. About this Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Section 2. Product Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Section 3. Radio Node Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Section 3.1 Radio Node Cover-Side and Mounting-Side Views . . . . . . . 7
Section 4. Connectors, SFP+ and Micro-USB Ports, and Status LED . . . . . . . . 8
Section 4.1 Duplex Phoenix Power Cable Ports . . . . . . . . . . . . . . . . . . . . . 8
Section 4.2 SFP+ Transceiver Port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Section 4.3 Micro-USB Port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Section 4.4 Status LED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Section 5. System Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Section 6. Compliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Section 7. Mounting the Radio Node . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Section 7.1 Flush Mounting the SCRN-510 . . . . . . . . . . . . . . . . . . . . . . . . . .11
Section 7.2 Downtilt Mounting the SCRN-510. . . . . . . . . . . . . . . . . . . . . . 12
Section 8. Cabling Guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Section 9. Completing the Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Section 10. Detaching the Radio Node from the Mounting Brackets . . . . . 14
Section 11. Radio Node LED Boot Sequence . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Section 12. Radio Node LED Management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Section 12.1 Disabling the LED display . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Section 12.2 Re-Enabling the LED Display. . . . . . . . . . . . . . . . . . . . . . . . . . 16
Section 13. Corning Documentation Set . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17