User manual

16
3-4. Extra Connection
Various devices such as headphone, professional amplifier, decoder, turntable, USB devices,
computers, routers can be connected to the X10 due to the different connectors on the rear of
the device.
4. Turn On and Start
4-1. Wizard Setup (Setup Assistant)
Without HDD installed; if you are installing the HDD you will meet the Setup Assistant (Wizard
Setup) as shown below. Switch the unit on at the rear of X10 and then power it on with the
remote controller or the power button on the top of the X10.
Select OK and confirm with the OK key to start Wizard Setup. If you want to run the set up after
booting up, you can select CANCEL at the 1
st
step.
【 TIP ① 】 You will be asked about formatting the HDD only if the HDD installed has not been
NOT formatted.
4-2. Turn ON for normal use
Switch the unit on at the rear of the X10 and power it on using the remote control or the power
button on the top of the X10 – The X10 should take about 66 seconds to boot up as it is looking
to see if a network is connected.
【 TIP ① 】 After you press the power button on it will take around 20 seconds to reach the
Cocktail Audio Logo screen.