User manual

5-6-5-1.Brand New HDD(not partitioned HDD)

① Install the HDD into the X10 and power it ON. ② Go to System of SETUP, and select HDD

Format, as shown below. ③ Confirm with the OK key and the HDD Format screen will appear:

⑤Press the OK key to start the format process, which will run as follows; (HDD unmounting ---Æ

Partition Resetting --Æ NTFS Formatting) see sequence below.

※The X10 re-boots automatically after finishing the HDD format.

5-6-5-2.Used HDD(partitioned HDD)

① Go to HDD Format of SETUP, and confirm with the OK button. ② The HDD Info screen will be

displayed as shown below. ③ Press the OK button to move to the next step. ④ Select OK and

confirm with the OK button. The formatting process will begin. The next procedure is the same as

above.

[Warning] HDD format will clear all data in the HDD!

5-6-6. NTFS Fix

You can check and fix the NTFS file system of the X10 HDD as follows.

Select NTFS Fix and confirm with the OK key.

【 Caution 】 We recommend you do NOT to run this function if the NTFS file system of the X10

hard disk has no problems.