User manual

5-7-3. Update by auto(Automatic Firmware Update by network)

The X10 will automatically update the firmware through the network. If you don’t wish this done

automatically you can change the setting to OFF, see below.

※ Default is ON

5-7-4. What’s Automatic Firmware Update by network ?

This function is only available with X10’s loaded with version; R1577 or higher and only when

connected to a network(internet). In the instance that a higher version of the firmware exists at

our server system, your X10 will check it automatically when the X10 boots up.

※ If OK is selected the X10 will try downloading and extracting it automatically. The X10 will

reboot automatically to update the firmware, see sequence below:

5-8-1. Time Set(Internet)

【 TIP 】 Make sure that the X10 is connected to network (internet) before you try time setting by

Time Set (Internet).

① Select Time Set (Internet) and

confirm it with the OK button. All the

time options will be displayed as

below.

※ If CANCEL is selected, the folder[New Firmware] is

created automatically in the internal hard disk(or USB), then

the X10 will not ask for a Firmware Update when booting

up. If you delete [New Firmware] through Browser, it will ask

again.

[TIP] There is no actual data in the [New Firmware] folder.