User`s manual

SUN-500 CURTAIN/SUN BLIND SWITCH
4
COM
i
Explanation: The module contains 2 switches.
These terminals have no connection to the 230
VAC on F and N and are voltage-free. This makes
it possible to switch low-voltage motors without
any problem! In the rest position, the common
contact (COM) is not switched. After an on/off
signal from your COCO transmitter, this switches
either to the left or the right contact. A built-in
timer always switches the COM contact back to
the rest position after approx. 2 minutes!
[5] Connect the switch wires of the motor that
drives your curtains or sun blind. How this is
connected is dependent on the situation and the
type of motor you wish to control! See the following
instructions “5A through 5D”.
If in doubt, consult the supplier of your sun blind
system!