Installation Manual

INSTALLATION

INSTALLING YOUR COCOON CAM

SYSTEM

Proper installation of your Cocoon Cam system is necessary in order for you to receive the most

accurate breathing monitoring readings.

Please follow the installation instructions carefully. In just 5 quick steps (5 minutes or less!)

you'll be all set up to start monitoring your baby's breathing with your new Cocoon Cam system!

Step 1: Measure the width of your crib on the long side. Find the center of that measurement,

and mark the wall using a piece of tape or a pencil.

PAGE 1
INSTALLATION INSTALLING YOUR COCOON CAM SYSTEM Proper installation of your Cocoon Cam system is necessary in order for you to receive the most accurate breathing monitoring readings. Please follow the installation instructions carefully. In just 5 quick steps (5 minutes or less!) you'll be all set up to start monitoring your baby's breathing with your new Cocoon Cam system! Step 1: Measure the width of your crib on the long side.
PAGE 2
Step 2: Measure 5 feet straight up from the surface of the mattress, and mark the wall, using a piece of tape or a pencil.
PAGE 3
Step 3: Using the holes in the camera mount as a guide, mark the location of the screw holes with a pencil. Make a small pilot hole (with the point of a screwdriver) over each screw hole location, and then push the provided drywall anchors into the wall. Position the camera on top of the drywall anchors and use the provided screws to secure the camera stand into the drywall anchors and wall.
PAGE 4
Step 5: Adjust the camera angle to give a complete view of the crib and only the crib. For best results, the camera must have visibility into all four corners of the mattress, with a "bird's eye" view. Tighten the collar on the camera stand to lock the camera into your desired position.