Instruction manual

5
After Sales Support
Telephone: [phone]
Internet: www.winplus.com.au
1. GETTING STARTED
Power the eBook Reader On and Off
- Press and hold the power button for 3 seconds to turn on. This is located on the bottom
of the unit
- It may take a few moments for the eBook Reader to turn on and load the content
- If the eBook Reader does not turn on then charging may be required
- To turn the eBook Reader off, press and hold the power button for 3 seconds
Charging the eBook Reader
Note: You will need to charge your eBook Reader for at least 6 hours before first use
- Connect the eBook Reader to a spare port on your PC using the included USB cable to
begin charging. (Note: your PC must be turned on)
- While charging, the eBook Reader will enter standby mode if it is idle for 60 seconds
You can press the power button to wake up the reader
- The battery status is displayed at the bottom left corner of the screen. The remaining
battery time is shown next to the battery icon
2. INSERTING A MEMORY CARD
The eBook Reader supports MicroSD cards in both FAT32 and NTFS format
Note: NTFS format is needed to copy files larger than 4GB to the MicroSD card
To insert a MicroSD card:
- Check that the MicroSD card is in the correct position with the copper contacts facing
upwards as shown. You may damage the MicroSD and the eBook Reader if the card is
not inserted correctly
- Push the MicroSD card into the card slot until it clicks
- To remove the MicroSD card, push the card in slightly
until it clicks and pops out
6
After Sales Support
Telephone: [phone]
Internet: www.winplus.com.au
3. TIPS & SHORTCUTS
- When a MicroSD card is inserted it may take a few seconds for the eBook Reader to
update the content
- Avoid inserting or ejecting a MicroSD card when the eBook Reader is in use. This may
freeze the system or cause it to reset
- When the MicroSD card is in NTFS format; you cannot directly copy files from the
eBook Reader internal memory to the MicroSD card
Home Menu
Screen Display
1. Continue Reading
Displays the last read book. Press
OK to continue reading from where
you left off
2. File Directory
Indicates the location where the
file is stored. SD – SD card, INT –
internal memory
3. Library
Displays the list of books available.
Move the cursor to desired book
and press the OK button to open it
4. Battery Indicator
Displays how much battery is left
5. Page Number
Displays current page number and
total available pages in the eBook
library
6. Time & Date
Display current time and date. This
can be set in the settings menu see
page 18 for details