Stereo Amplifier CSX OPERATION MANUAL T E C H N O L O G I E S I N C .
SAFETY PRECAUTIONS 1 CAUTION WARNING ! CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THIS SYMBOL IS TO ALERT YOU OF THE PRESENCE OF UNINSULATED DANGEROUS VOLTAGE WITHIN THE UNIT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK. ! THIS SYMBOL IS INTENDED TO ALERT YOU OF THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE UNIT.
INTRODUCTION 2 This amplifier is a precision device, designed in an effort to provide the listener with unmatched sound quality, design, and construction. In order to operate your amplifier properly and to realize all of the capabilites of the AMPLIFIER CSX, we recommend that you read this entire manual carefully.
DESCRIPTION 3 In early 2004, development began on the long awaited successor to the Stage 3 Amplifier. Our design goals were nothing less than improvements in sonics and industrial design sufficient to raise this product series up into the more prestigous and well known "Coda" product line. At about the same time, another well-known audio manufacturer commissioned Coda to develop a cost-no-object reference monoblock amplifier and reference preamplifier.
DETAILED INSTALLATION 4 I. Source-Output, Power Connections and Controls The connectors and controls are clearly marked on the back panel of the AMPLIFIER CX. Note the correct left or right channel orientation. The function and channel markings on the rear panel correspond to the front panel controls and their signal paths. 1.
CARE and HANDLING 5 The interior of the unit requires no special care. If it becomes necessary to clean the exterior, a simple dusting may be all that is required. If a cleaner is necessary, any dilute commercial ammonia based product will be appropriate. NEVER use any abrasive rags, cleaners or chemical solvents on Coda products. When handling the unit, take care not to mar the aluminum. Aluminum is a medium hardness metal and can be scratched by the harder tool steels.
SPECIFICATIONS R AT E D POWE R 330 Watts x2 into 8 Ohms 660 Watts x2 into 4 Ohms 1 Ohm load stable Class A to 10 Watts B ANDWIDT H DC or -3dB at 5 Hz through 100kHz depending on input DIS T OR T ION Les s than .03% from 10Hz to 20kHz at 350 Watts both channels driven into 4 through 8 Ohms GAIN 26dB CUR R E NT CAPAB IL IT Y 150 Amperes peak S L E W R AT E 50 Volts /micros ecound INPUT IMPE DANCE 50k Ohms unbalanced/1k Ohms balanced OUT PUT IMPE DAN DANCE .
7850 CUCAMONGA AVENUE #34 SACRAMENTO, CA 95826 USA T E C H N O L O G I E S I N C . phone +01 916.383.3653 fax +01 916.455.3653 on the web at CODA.CC email us at info@coda.