User guide

Stereo Amplifier Configuration
WARNING: Please ensure that the power switch is turned OFF while you are connecting the
amplifier. Connecting or disconnecting cables while the amplifier is powered on could
cause damage to your speakers.
NOTE: Ensure that the mode switch located between the input jacks on the rear of the
amplifier is set to the stereo position for normal operation. Bridged operation is explained on
page 7.
The diagram below shows the default connections necessary to operate the 33.0 as a
stereo amplifier. This is the simplest and most common mode of operation, and the quickest
way to get started. Once these connections are made you can turn the power switch on,
enable the bias from the front panel and start listening to your amplifier.
For simplicity this diagram shows an audio configuration using balanced interconnects. This
is the default input mode of the amplifier. Unbalanced operation requires that you set the
appropriate input mode as detailed on page 5.
INITIAL SETUP 3
LEFT SPEAKER RIGHT SPEAKER
PREAMPLIFIER
AMPLIFIER 33
!
FOR CONTINUED PROTECTION AGAINST
SHOCK OR FIRE HAZARD,DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
AC LINE INPUT
SEE SERIAL T AG FOR
POWER REQUIREMENTS
~
UNBALANCED INPUT
RIGHTLEFT
COMPACT DISC
RIGHTLEFT
TUNER
RIGHTLEFT
VIDEO
RIGHTLEFT
MONITOR
RIGHTLEFTRIGHTLEFT
IN
OUT
PROCESSOR
RIGHTLEFTRIGHTLEFT
IN
OUT
VIDEO
RIGHTLEFT
UNBALANCED OUTPUT
RIGHTLEFT
DO NOT CONNECT AMPLIFIER OUTPUT
TERMINALS TOGETHER. CONNECT
AMPLIFIER OUTPUT TERMINALS ONLY TO
SPEAKERS.
FOR CONTINUED PROTECTION AGAINST
SHOCK OR FIRE:
REPLACE FUSE WITH SAME TYPE AND
RATING. DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE
SEE SERIAL TAG FOR POWER REQUIREMENTS.
REMOVE POWER CORD BEFORE CHANGING FUSE OR LINE VOLTAGE.
AC LINE INPUT MAIN POWER FUSE / VOLTAGE SELECTOR
READ THE BRIDGING SECTION OF THE OPERATING MANUAL OR CONTACT YOUR CODA AUTHORIZED
DEALER TO SET THE BRIDGING SWITCHES
BRIDGED MODE
16 AMP
16 AMP
8 AMP
8 AMP
UNBALANCED
BRIDGED
INPUTS
INPUTS
BALANCED
BALANCED
INPUTS
UNBALANCED
PUSH PUSH
230