User's Guide
Table Of Contents
DANIELS
ELECTRONICS LTD
TM
CI-PM-3 Paging Modulator Instruction Manual 3-9
3.13.2.1 Digital-Only Repeater
1. Install shunt jumpers JU41-C and JU23-A, JU23-B or JU23-C.
2. Install surface mount jumpers JU7-B, JU8-B, JU10-A, JU19/JU45, JU20/JU21, JU22,
JU29/JU43, and JU55.
3. Remove surface mount jumpers JU34, JU51, JU52, JU53 and JU54.
3.13.2.2 Analog/Digital Repeater
Ensure the TS-64 CTCSS Module, MOD1, is installed. Refer to section 3.13.3 for TS-64 CTCSS
Module Configuration and settings for jumpers JU52, JU53 and JU54.
1. Install shunt jumpers JU7-B, JU8-B, JU10-B, JU41-A and JU23-A, JU23-B or JU23-C.
2. Install surface mount jumpers JU19/JU45, JU20/JU21, JU22, JU28, JU29/JU43, JU30/JU44
and JU55.
3. Remove surface mount jumpers JU34 and JU51.
3.13.3 TS-64 Configuration
1. Ensure POLARITY jumper JP7 is installed.
2. For normal operation (i.e. receiver audio is muted until a CTCSS coded transmission is
received):
a) Ensure TS-64 jumper JP11 is removed.
b) Ground the TS-64 Hang-up Input:
i) Install jumper JU52, or
ii) Remove jumper JU52, install jumper JU53 and ground CTCSS HU/BUSY input J1
Pin 11.