User's Guide

DANIELS
ELECTRONICS LTD
TM
CI-PM-3 Paging Modulator Instruction Manual 4-5
REF.
DESIG. DESCRIPTION
JUMPER
TYPE
DEFAULT
POSITION
JU51 Repeater Digital-Only PTT Enable SM Solder Installed
JU52 TS-64 Hang-up RX Mute SM Solder Not Installed
JU53 TS-64 Busy Input Enable SM Solder Not Installed
JU54 TS-64 Busy Input Connect to COR SM Solder Not Installed
JU55 TS-64 Repeater PTT Enable (Analog/Digital only) SM Solder Not Installed
JU56 Switched 9.5 Volts For Reference Input Circuitry SM Solder Not Installed
JU57 U18 (14174 IC) enable SM Solder Not Installed
JU58 Data regeneration SM Solder Not Installed
JU59 PLL calibration reference SM Solder Not Installed
JU60 U4 or U4A select SM Solder Not Installed
4.5 TS-64 MOD1 Jumper Settings - (If installed)
Table 4-5 CTCSS Jumper Settings
REF.
DESIG. DESCRIPTION
DEFAULT
POSITION
JP1-JP6 CTCSS Tone Frequency Select *
JP7 RX Audio Mute Polarity (Installed: Mute = Open, Not Installed: Mute = Ground) Installed
JP8-JP10 TX Time-Out-Timer Interval Select *
JP11 Hang-Up/Busy-Input Configure (Installed = Busy-Input, Not Installed = Hang-Up Input) Not Installed
Note: Refer to TS-64 Instruction Sheet for configuration details.
4.6 4-Level Modulation Bit Pattern
Table 4-6 4-Level Modulation Bit Pattern
J1-PIN1
(BIT 0)
J1-PIN2
(BIT 1)
DEVIATION
SETTING
0 0 - 4800 Hz
0 1 - 1600 Hz
1 1 + 1600 Hz
1 0 + 4800 Hz
4.7 Receiver IF / Audio PCB Jumper Settings
Table 4-9 Receiver IF / Audio PCB Jumper Settings
JUMPER POSITION
JU5 Short
JU25 Short
JU37 Open
Note: All other jumper settings as per the factory defaults.