User's Guide

Table Of Contents

DANIELS

ELECTRONICS LTD

iv CI-PM-3 Paging Modulator Instruction Manual

ALIGNMENT PROCEDURE AND INSTALLATION CONTINUED

3.13 Repeater Configuration......................................................................................... 3-8

3.13.1 Base Transmitter Site CI-PM-3 Configuration ............................................... 3-8

3.13.1.1 Digital-Only Paging.................................................................................. 3-8

3.13.1.2 Analog/Digital Paging............................................................................... 3-8

3.13.2 Repeater Site CI-PM-3 Configuration ............................................................ 3-8

3.13.2.1 Digital-Only Repeater............................................................................... 3-9

3.13.2.2 Analog/Digital Repeater............................................................................ 3-9

3.13.3 TS-64 Configuration....................................................................................... 3-9

4 CONNECTOR PIN FUNCTIONS AND JUMPER FUNCTIONS.................................... 4-1

4.1 Data / Control Port (Connector J1) Pin Functions................................................ 4-1

4.2 Motherboard Interface (Connector P1) Pin Functions.......................................... 4-1

4.3 CI-PM-3 Data Delay Jumper Settings.................................................................. 4-3

4.4 CI-PM-3 Circuit Board Jumpers .......................................................................... 4-4

4.5 TS-64 MOD1 Jumper Settings - (If installed)...................................................... 4-5

4.6 4-Level Modulation Bit Pattern............................................................................. 4-5

4.7 Receiver IF / Audio PCB Jumper Settings............................................................ 4-5

4.8 Transmitter Audio Processor Jumper Settings...................................................... 4-6

4.9 Transmitter Synthesizer Jumper Settings.............................................................. 4-9

4.10 CI-PM-3 Test Points .......................................................................................... 4-10

5 ILLUSTRATIONS AND SCHEMATIC DIAGRAMS ....................................................... 5-1

5.1 CI-PM-3 Front Panel Controls............................................................................. 5-1

5.2 Simulcast Paging Example.................................................................................... 5-2

5.3 CI-PM-3 Component Layout (Through-Hole Side) ............................................. 5-3

5.4 CI-PM-3 Component Layout (Surface-Mount Side)............................................ 5-4

5.5 CI-PM-3 Schematic Diagram ............................................................................... 5-5

5.6 CI-PM-3 Schematic Diagram ............................................................................... 5-6

5.7 CI-PM-3 Schematic Diagram Component Location Table.................................... 5-7

6 PARTS LISTS ...................................................................................................................... 6-1

6.1 CI-PM-3 Electrical Parts List................................................................................ 6-1

6.2 CI-PM-3 Mechanical Parts List............................................................................ 6-5

7 REVISION HISTORY.......................................................................................................... 7-1